Galaxy DX 93T 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Galaxy DX 93T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy DX 93T 11 페이지. 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate

페이지 인쇄

1. Front Panel

REAR PANEL

1. ANTENNA: This jack accepts a 50 ohm coaxial cable with a PL-259 type

plug.

2. DC POWER: This jack accepts the 13.8V DC power cable with built-in

fuses. The power cord provided with the radio has a black and red wire. The

black goes to negative and red goes to positive.

3. PA SP: This jack is for PA operation. Before operating, you must first

connect a PA speaker (8 ohms, 4W) to this jack.

4. EXT. SP: This jack accepts a 4 to 8 ohm, 5 watt external speaker. When the

external speaker is connected to this jack, the built-in speaker will be

disabled.

ANT.

PA.SP.

POWER

- 8 -

PROCEDURE TO RECEIVE AND TRANSMIT

A. MICROPHONE

The push-to-talk switch on the microphone controls the receiver and transmitter.

Press the switch and the transmitter is activated, release switch to receive. When

transmitting, hold the microphone two inches from your mouth and speak clearly

in a normal voice. This transceiver comes complete with a low impedance

dynamic microphone.

EXT.SP.

B. PROCEDURE TO RECEIVE

1. Be sure that power source, microphone and antenna are connected to the

proper connectors before going to the next step.

2. Turn VOL knob clockwise to apply power to the radio.

3. Set the VOL for a comfortable listening level.

4. Set the MODE switch to the desired mode.

5. Listen to the background noise from the speaker. Turn the SQ knob slowly

clockwise until the noise just disappears. The SQ is now properly adjusted.

The receiver will remain quiet until a signal is actually received. Do not

advance the control too far or some of the weaker signals will not be heard.

6. Set the CHANNEL selector switch to the desired channel.

7. Adjust COARSE/FINE control to clarify the SSB signals or to optimize

AM/FM signals.

C. PROCEDURE TO TRANSMIT

1. Select the desired channel of operation.

2. Set the MIC GAIN control fully clockwise.

3. If the channel is clear, depress the push-to-talk switch on the microphone and

speak in a normal voice.

- 9 -

- 6 -