Galaxy DX 93T 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Galaxy DX 93T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy DX 93T 11 페이지. 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate
페이지 인쇄
ALTERNATE MICROPHONES AND INSTALLATION
For best results, the user should select a low-impedance dynamic type
microphone or a transistorized microphone. Transistorized type microphones
have low output impedance characteristics. The microphones must be provided
with a four-lead cable. The audio conductor and its shielded lead comprise two of
the leads. The third lead is for transmit control and fourth is for receiving control.
The microphone should provide the functions shown in the schematic below.
4 WIRE MIC CABLE
Pin Number
1
2
3
4
Fig. 1 Your transceiver microphone schematic.
If the microphone to be used is provided with pre-cut leads, they must be
revised as follows.
1. Cut leads so that they extend 7/16" beyond the plastic insulating jacket of the
microphone cable.
2. All leads should be cut to the same length. Strip the ends of each wire 1/8"
and tin the exposed wire.
Mic Cable Lead
Audio Shield
Audio Lead
Transmit Control
Receive Control
- 12 -
Before beginning the actual wiring, read carefully the circuit and wiring
information provided with the microphone you select. Use the minimum heat
required in soldering the connections. Keep the exposed wire lengths to a
minimum to avoid shorting when the microphone plug is reassembled.
Fig. 2 Microphone plug wiring
To wire the microphone cable to the plug provided, proceed as follows:
1. Remove the retaining screw.
2. Unscrew the housing from the pin receptacle body.
3. Loosen the two cable clamp retainer screws.
4. Feed the microphone cable through the housing, knurled ring and washer as
shown Figure 2.
- 13 -