909 BS9 사용 설명서 - 페이지 5
{카테고리_이름} 909 BS9에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 BS9 16 페이지. 230mm (9") band saw
페이지 인쇄
4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
The correct power tool will
Properly
i) Children should be supervised to ensure that they do
not play with the appliance.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is maintained.
b) If the supply cord is damaged, it must be replaced by
the manufacturer,
its service agent or similarly qualified
persons in order to avoid a hazard.
Additional safety rules for band saws
Ensure that the lighting is adequate.
•
Keep the area free of tripping hazards.
•
Do not let anyone under 18 years operate this saw.
•
•
Always stand to one side when operating the saw.
•
Never use a cracked or distorted saw blade. Only use
sharp blades.
•
When cutting round wood, use clamps that prevent the
work piece from turning on the table.
•
Never use your hands to remove sawdust, chips or waste
close by the saw blade.
•
Use only blades as recommended.
•
Rags, cloths, cord, string and the like should never be left
around the work area.
•
Avoid cutting nails. Inspect the workpiece and remove all
nails and other foreign objects before beginning sawing.
•
Support the work properly.
•
Never reach over the blade to remove waste or off cuts.
•
Do not attempt to free a jammed blade before first
switching off the machine.
•
Do not slow or stop a blade with a piece of wood. Let the
blade come to rest naturally.
•
If you are interrupted when operating the saw, complete
the process and switch off before looking up.
•
Periodically check that all nuts, bolts and other fixings are
properly tightened.
5
This