909 DP250LS 사용 설명서 - 페이지 13
{카테고리_이름} 909 DP250LS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 DP250LS 16 페이지. 1/3 hp 5 speed drill press with laser
페이지 인쇄The motor is spring loaded when the tension knob is
loose and the motor should not need to be pushed back.
Just tighten the tension knob after the belt position is set.
Should the belt slip during operation, loosen the tension
knob and apply slight pressure to the motor to the point
where the belt tension can be felt. Re-tighten the tension
knob.
7. Rotate the pulley by hand to ensure everything is aligned
and correct.
8. Lower the pulley cover and replace the pulley cover
screw. Tighten the pulley cover screw to secure the pulley
cover in the closed position.
Note.
NEVER attempt to operate the drill press with the top
cover open and not securely closed with the locking screw.
Turning on and off
1. Insert the switch disabling insert and ensure the switch
(3) is in the OFF position.
2. Ensure the pulley cover is in the fully closed position.
3. Lift the switch to the ON
position (I) to turn on and
operate the drill press.
4. Push the switch down to
the OFF position (0) to
turn off the drill press.
Turning on the laser line generator
1. The laser line generator emits
two intense narrow beams of
pure red light that intersect at
the drilling point.
2. The intersection is clearly
visible and will not be
obscured by dust. It improves
operator drilling vision, enables
faster set-up, increases
accuracy and improves safety.
3. To turn the laser line on press
the laser light on/off switch (1).
4. To turn off the laser line press
the laser light on/off switch (1).
Adjusting the laser
1. Clamp a scrap piece of
material to the table.
2. Insert a drill bit into the chuck jaws.
3. Turn on the drill press.
4. Using the feed handle lower
the spindle and make a small
mark in the workpiece.
5. Turn on the laser line
generator. If the laser is not
aligned with the mark in the
workpiece, adjust as follows.
6. Using the 3mm hex key loosen
the set screw that secures the
laser light assembly.
13