909 DP250LS Instruction Manual - Page 13

Browse online or download pdf Instruction Manual for Drill 909 DP250LS. 909 DP250LS 16 pages. 1/3 hp 5 speed drill press with laser

Print Page

The motor is spring loaded when the tension knob is

loose and the motor should not need to be pushed back.

Just tighten the tension knob after the belt position is set.

Should the belt slip during operation, loosen the tension

knob and apply slight pressure to the motor to the point

where the belt tension can be felt. Re-tighten the tension

knob.

7. Rotate the pulley by hand to ensure everything is aligned

and correct.

8. Lower the pulley cover and replace the pulley cover

screw. Tighten the pulley cover screw to secure the pulley

cover in the closed position.

Note.

NEVER attempt to operate the drill press with the top

cover open and not securely closed with the locking screw.

Turning on and off

1. Insert the switch disabling insert and ensure the switch

(3) is in the OFF position.

2. Ensure the pulley cover is in the fully closed position.

3. Lift the switch to the ON

position (I) to turn on and

operate the drill press.

4. Push the switch down to

the OFF position (0) to

turn off the drill press.

Turning on the laser line generator

1. The laser line generator emits

two intense narrow beams of

pure red light that intersect at

the drilling point.

2. The intersection is clearly

visible and will not be

obscured by dust. It improves

operator drilling vision, enables

faster set-up, increases

accuracy and improves safety.

3. To turn the laser line on press

the laser light on/off switch (1).

4. To turn off the laser line press

the laser light on/off switch (1).

Adjusting the laser

1. Clamp a scrap piece of

material to the table.

2. Insert a drill bit into the chuck jaws.

3. Turn on the drill press.

4. Using the feed handle lower

the spindle and make a small

mark in the workpiece.

5. Turn on the laser line

generator. If the laser is not

aligned with the mark in the

workpiece, adjust as follows.

6. Using the 3mm hex key loosen

the set screw that secures the

laser light assembly.