909 LT18HT 사용 설명서 - 페이지 13
{카테고리_이름} 909 LT18HT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 LT18HT 16 페이지. 18v cordless hedge trimmer
페이지 인쇄Using the hedge trimmer
Safety features
1. The cutting blade is
supplied with a sheath
type cover. Keep the cover
on the blades when ever
the tool is not being used.
2. When the hedge trimmer
is not being used it is
suggested to remove the
battery pack to prevent
unauthorised use of the
tool.
3. The rear handle trigger switch (1) and front handle bar
switch (2) must be operated together to start the motor.
This ensures that both hands are used to control the
trimmer.
4. If either of the two switches is released, the tool is
designed to stop rapidly.
Switching on and off
1. To switch on, press both
the trigger switch (1) and
the bar switch (2) at the
same time.
2. To switch off, release
either switch.
Safety points during
operation.
•
Wear eye protection when using this tool.
•
Always use two hands to hold the tool. One on the rear
handle and one on the front loop handle.
•
Always ensure good balance. Both feet should be firmly
on the ground.
Shaping
1. Trim a hedge so that it is
wider at the bottom than
the top.
2. This improves light
penetration and promotes
healthy growth.
3. Narrow the hedge
approximately 100 mm for
every metre in height.
4. A bush can be round or
column shaped.
Cutting
1. Assume a secure position,
using two hands to hold the
trimmer and switch on.
2. Trim both sides of the
hedge, starting at the
bottom. This prevents
cuttings falling into the area
yet to be cut.
3. Pass the blade lightly through the surface of the hedge.
Do not attempt to cut too deep.
4. Trim the top of the hedge.
5. For older hedges that
require cutting back
substantially, use pruning
shears to cut the thicker
branches and
then finish the job with the
hedge trimmer.
WARNING.
Do not let the blade come into contact with
fencing wire or any other object that could damage it.
13
�����
�����