909 LT18HT 사용 설명서 - 페이지 14

{카테고리_이름} 909 LT18HT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 LT18HT 16 페이지. 18v cordless hedge trimmer

페이지 인쇄

Pruning

Your hedge trimmer is versatile. It can also be used for

trimming back new growth from small shrubs onto the

driveway or into the garden.

General inspection

1. Regularly check that all the fixing screws are tight. They

may vibrate loose over time.

Maintenance

1. Store the tool, instruction manual and accessories in a

secure, dry place. In this way you will always have all the

information and parts ready to hand.

2. Keep the tool's air vents unclogged and clean at all times.

3. Remove dust and dirt regularly. Cleaning is best done

with compressed air or a rag.

4. Never use caustic agents to clean plastic parts.

5. Remove battery from tool during storage.

6. Replace blade cover when the tool is not being used.

CAUTION.

Do not use cleaning agents to clean the plastic

parts of the tool. A mild detergent on a damp cloth is

recommended. Water must never come into contact with

the tool.

Blade maintenance

Wear gloves when handing or cleaning the cutting blade.

Always clean the cutting blade after operation and lubricate

with protective spray. During longer cutting jobs, we

recommend periodically lubricating the cutting blade with

protective spray.

Visually check the condition of the cutting edges of the

cutting blade. Check tightness of blade bolts. Ensure that

the blade is covered with the blade protection supplied.

Lubrication

WARNING.

Switch off and remove the battery before

carrying out any maintenance on the tool.

After each use, clean the blades and lightly lubricate

with general purpose oil or spray lubricant.

Troubleshooting

No power

The hedge

trimmer operates

intermittently

Motor runs but

blades remain

stationary

The blade is not

working

1. Check the battery if it is

charged or not.

2. Any of the parts are

defective, such as On/Off

switch / motor etc. (please

contact service agent).

1. Any of the two handle

switches are defective

(please contact service

agent).

2. Battery is nearly empty.

3. Internal loose electrical

connection.

4. On/Off switch defective

(please contact service

agent).

1. Internal fault (please contact

service agent).

1. Cutting blade blunt (have

blade sharpened).

2. Cutting blade has dents

(have blade overhauled).

3. Too much friction, due to

lack of lubricant (apply

lubricant spray).