909 RH600HT 사용 설명서 - 페이지 8

{카테고리_이름} 909 RH600HT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 RH600HT 12 페이지. 600w 660mm hedge trimmer with rotating handle

페이지 인쇄

Cable safety clip

WARNING.

Extension cord must

be approved for outdoor use.

Locate the rectangular slot in

the lower part of the rear handle

and the position of the cable

safety clip (9). Form a loop in

the extension cord (not supplied)

and insert the loop through the

rectangular slot. Twist the loop

through 180° and hook the loop

over the moulded hook, pull tight

to secure the cable.

Before operation

•

Ensure the guard is fitted correctly

•

Push the guard into its location at the front of the housing

•

Using a posidrive screwdriver (not supplied) screw the

screws into the holes already on the unit.

WARNING:

The hedgetrimmer must not be operated

without the guard fitted

Operation

IMPORTANT.

This hedge trimmer is designed for the

trimming of hedges, bushes and shrubs. If it is used for any

other purpose not expressly permitted by these operating

instructions, there may be a risk of damage to the hedge

trimmer or serious injury to the user.

Note.

The upper blade teeth have extended points with

rounded ends to reduce the chance of injury in case of

accidental contact.

Switching on and off

Note.

This hedge trimmer is fitted with a two-hand

safety switch.

1. To switch the hedge trimmer on, press the front safety

switch on the front grip is pressed with one hand and

either trigger switch with the other hand.

2. To stop the hedge trimmer move the Hedge Trimmer

away from the cutting area and release either one, or

both of the switches.

Rotating the rear handle

WARNING.

Never engage the

switch trigger while rotating

the handle.

This hedge trimmer is fitted with

a rear rotating handle. It can be

turned 45 deg and 90 deg to the

left and 45 deg and 90 deg to the right.

It has fixed positions and the lock button will locate and lock

the handle in each position

1. To rotate the handle pull the switch backwards and rotate to

the position required and the switch will slide back into position.