909 50620 사용자 설명서 - 페이지 9

{카테고리_이름} 909 50620에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 50620 19 페이지. 139cc 4 stroke petrol lawn mower

페이지 인쇄

Assembly

WARNING: Stop the engine and unplug the spark plug before any

repairs or maintenance operations.

WARNING: DO NOT attempt to start this mower without first adding

0.6L of SAE 10W/30 engine oil to the Engine.

WARNING: Do Not attempt to start this mower without the mower

first being FULLY assembled.

It is necessary to fit the lower handles (6), upper handle bar and handles (1),

and 45L hard catcher (7) to the mower.

Attaching the Handles

1. To attach the lower handles (6), first remove the two lower handle locking

knobs (8). Place the lower handle in position by aligning the 2 lower

handle ends on the inner side of the lower handle mounting plates (9)

located at the back of the mower deck. (Fig A)

2. Once in position, insert the bolt on each side through the lower handle

(6) and then through the lower handle mounting plate (9).

Orientate the bolt so the head sits correctly in the depression in the

handle tube. (Fig B)

3. Once the bolts are loosely in position, fit the plastic curved washer over

the end of the bolt. Then screw the lower handle bar locking knob (8)

over the plastic curved washer and secure by turning clockwise until tight

and secure. (Fig C)

e-mail: [email protected]

MODEL: №. 50620

139cc 4 Stroke Petrol Lawn Mower

LOOSEN

TIGHTEN

AFTER SALES SUPPORT

1800 909 909

(toll free)

139cc 4 Stroke Petrol Lawn Mower

4. After securing the lower handles in to position, extend the upper handle

bar into the upright position, (Fig D) and then simply secure the upper

handle locking knobs (5) that are already loosely in position. (Fig E)

5. Check the on/off switch cable (3) is correctly routed and secured with the

supplied cable clip (4). (Fig F)

WARNING. When opening up the upper handle bar take care NOT

to pinch the switch cable in the hinging of the handle bars and

ensure the cable is not trapped within the bars being clamped.

Assembly of the 45L Hard Catcher

WARNING. Ensure the motor is off and

not operating when undertaking this task.

1. The 45L hard catcher (7) is supplied in two

sections. Locate the top half on top of the

bottom half and interlock them together by

aligning the lugs and slots, and pushing the

halves together until they click into place. (Fig G)