DYNAPAR NorthStar SLIM Tach SL56 사용 설명서 - 페이지 7
{카테고리_이름} DYNAPAR NorthStar SLIM Tach SL56에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNAPAR NorthStar SLIM Tach SL56 12 페이지. Slim tach magnetoresistive encoder, 0.625” to 3.000” thru-shaft diameter applications
페이지 인쇄2.0 Inspection and Unpacking
Inspect shipping container for external damage. All claims for damage (apparent or concealed) or partial loss of shipment must
be made in writing to Dynapar within (5) days from receipt of goods. If damage or loss is apparent, please notify the shipping
agent immediately.
Open shipping container and locate the packing list. The packing list is included to verify that all components, accessories, and
manual were received. Please use the packing list to check off each item as the unit is unpacked. Inspect for damage. We
recommend that the shipping container be retained for future shipping, storage, or return to factory purposes.
If any equipment was damaged in transit, be sure to file proper claims promptly with the carrier and insurance company. Please
advise us of such filing. In case of parts shortages, advise us immediately. Dynapar cannot be responsible for any missing parts
unless notified within 60 days of shipment.
2.1 Motor Facing and Shaft
To prepare the motor facing and shaft for installation, perform the following steps. See Figure 2.
1.
Clean outer rim and surface of motor facing and shaft of paint, grease, dirt, and other debris where SLIM Tach
unit contacts motor or accessory. Also ensure that mating surfaces have not been damaged and that unit will fit squarely
on motor.
2.
Apply a thin layer of corrosion preventative or oil to motor facing and shaft to aid assembly and provide some
corrosion protection.
Ensure there is no paint, burrs, protrusions, or deformations on the motor facing or
shaft. If the enclosure does not fit squarely on the motor facing, the alignment between
the sensor module and the magnetic pulse wheel may be degraded.
7
NorthStar SLIM Tach
CHAPTER 2
INSTALLATION
Figure 2: Typical 4.5-Inch Diameter Type 56 C-Face Mounting Surface
© DYNAPAR
SL56 Instruction Manual
®
N OTE
U
U
®
SL56
P
P
+1.800.873.8731