DYNAPAR NorthStar SLIM Tach SL56 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów DYNAPAR NorthStar SLIM Tach SL56. DYNAPAR NorthStar SLIM Tach SL56 12 stron. Slim tach magnetoresistive encoder, 0.625” to 3.000” thru-shaft diameter applications

Drukuj stronę

2.0 Inspection and Unpacking

Inspect shipping container for external damage. All claims for damage (apparent or concealed) or partial loss of shipment must
be made in writing to Dynapar within (5) days from receipt of goods. If damage or loss is apparent, please notify the shipping
agent immediately.
Open shipping container and locate the packing list. The packing list is included to verify that all components, accessories, and
manual were received. Please use the packing list to check off each item as the unit is unpacked. Inspect for damage. We
recommend that the shipping container be retained for future shipping, storage, or return to factory purposes.
If any equipment was damaged in transit, be sure to file proper claims promptly with the carrier and insurance company. Please
advise us of such filing. In case of parts shortages, advise us immediately. Dynapar cannot be responsible for any missing parts
unless notified within 60 days of shipment.

2.1 Motor Facing and Shaft

To prepare the motor facing and shaft for installation, perform the following steps. See Figure 2.
1.
Clean outer rim and surface of motor facing and shaft of paint, grease, dirt, and other debris where SLIM Tach
unit contacts motor or accessory. Also ensure that mating surfaces have not been damaged and that unit will fit squarely
on motor.
2.
Apply a thin layer of corrosion preventative or oil to motor facing and shaft to aid assembly and provide some
corrosion protection.
Ensure there is no paint, burrs, protrusions, or deformations on the motor facing or
shaft. If the enclosure does not fit squarely on the motor facing, the alignment between
the sensor module and the magnetic pulse wheel may be degraded.
7
NorthStar SLIM Tach
CHAPTER 2

INSTALLATION

Figure 2: Typical 4.5-Inch Diameter Type 56 C-Face Mounting Surface
© DYNAPAR
SL56 Instruction Manual
®
N OTE
U
U
®
SL56
P
P
+1.800.873.8731