909 EDG4 사용 설명서 - 페이지 11

{카테고리_이름} 909 EDG4에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 EDG4 13 페이지. 1200w lawn edger

페이지 인쇄

Operating

Edging

1. Set the cut depth at 25mm and set edge guide to the

down position.

2. The guard incorporates a

raised rib section which acts

as a blade cut indicator. This

rib will assist in guiding the

operator where the blade

will cut. During operation the

operator can sight down the

rib of the guard to where the

edge is to be cut.

3. Before starting the edger, line up the tool so the edge

guide rests against the edge of the paved surface,

both rear wheels should be on the paved surface when

edging.

HINT:

When there is heavy overgrowth of grass over the

paved surface it may drag on the guard. An initial cut

may be required with the edger on the grass side. This

will require lifting up the edger guide and may require

reducing the depth of cut.

4. To avoid kickback of the edger,

tilt the handle down so the

blade is above the ground.

5. Turn the edger on and allow

the blade to spin without

moving the tool.

6. Slowly raise the handle to

lower the blade, finding the

edge of the paved surface and start edging. Then move

forward slowly along the edge of the paved surface,

keeping the edge guide pressed lightly against the

pavement edge.

For the first edging each season, it is best to move forward

slowly because grass is thickest then. Subsequent edging

will be completed more rapidly. If the tool slows down, back

it up slightly until the blade returns to normal speed.

During edging some sparks may be generated from hitting

stones: this is normal. Do not attempt to edge when the

grass or soil is wet or moist; both for electrical safety and to

prevent clogging of the blade chamber.

Landscaping / Trenching

Before landscaping or trenching, inspect and ensure there

are no exposed or buried cables or pipes or other objects

that may create a hazard or interfere with operating the

edger. Lift the edge guide lever (5) for all trenching. Set the

depth to only that required for the job, do not overload, if

tool slows, pull back slightly and wait until the blade returns

to normal speed.

Cleaning the guard chamber

WARNING:

Ensure the tool is switched off and is

disconnected from mains power before cleaning the

guard chamber.

After each use the blade chamber should be cleared of

dirt and grass build-up, to maintain cutting efficiency.

1. Undo the guard lock knob (11)

and open the guard.

2. Use a stick or screw driver

to clean all debris build up in

the guard.

3. When finished retract the

guard and rensure the guard

lock knob is tightened.