909 EDG4 사용 설명서 - 페이지 9

{카테고리_이름} 909 EDG4에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 EDG4 13 페이지. 1200w lawn edger

페이지 인쇄

Setting up

Assembling the Shaft

The shaft must be assembled on removal from the carton.

Remove the bag containing the two small screws from

the shaft.

Note:

Before assembling the upper and lower shafts, you

will need to remove and discard the protector packaging.

1. Insert the lower shaft into the hole at the back of the unit.

Carefully feed the wire into the tube. Align the holes so

the bolt can be fed through.

2. Slide the upper handle on the

lower handle again align the

holes so the bolt and nut can

be fitted.

Handle fitment

Fit the secondary handle onto

the upper handle and rotate to

suit the operator and then tighten

the bolt.

Cord routing

Always make sure that you route the cord away from the

work area to prevent it from coming near the blade of the

edger. Lay your cable route before starting work.

Start your edger at the point nearest to the electrical socket,

and then move away whilst working. This will mean that the

cord will be pulled through the area that has already been

cut, thereby keeping it out of danger of being cut through

by the blade.

Cord Restraint

Your 909 EDG5-A is fitted with a cord restraint to prevent

the power cable from both being disconnected and also to

prevent excessive strain on the connecting plugs

during use.

It is recommended the cord

restraint is used as follows:

Approx 300mm from the end of

the extension cable, form a tight

loop in the extension cable, and

feed the loop through the square

hole beneath the handle. Place

the loop over the inner hook in

the handle to prevent the cable

pulling back through the square hole.

Switching on

Your 909 EDG5-A is fitted with

a lock off button to prevent

accidental operation.

To turn on the edger push in

the side lock off button and then

depress the switch fully.

Hold in the switch to maintain

power to the unit. To stop the

edger, release switch.

Take care when you turn the edger "On" that the cutter is in

a safe position to operate.