Hifonics zeus series 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Hifonics zeus series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics zeus series 8 페이지. Zeus series
Hifonics zeus series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (4 페이지), 사용자 설명서 (8 페이지), 매뉴얼 (12 페이지), 사용자 설명서 (13 페이지)

페이지 인쇄

INSTALLATION NOTES

The first step of installing a speaker system is thorough planning. Choose a suitable location for your speak-

er components carefully. Follow these suggestions to ensure proper imaging and maximum performance:

1. Choose a location that offers the least amount of obstruction between the components and your ears.

Pay also attention to the position of the seats, headrests and other constructional systems in the interior

space of the car.

2. Try to mount the speakers on the same arrangement. They should be installed at the same height and

directly across from each other. Do not mount one speaker higher, lower, further forward or further back-

ward from the opposite speaker.

3. The tweeter should always be installed as close as possible to the midbass speaker.

4. Always take a look behind the chosen mounting locations to ensure that there is proper clearance for

the rear of the speakers and avoid obstructions such as window tracks, wire harnesses, gas tank etc.

5. Maximum performance is achieved when the speaker is securely mounted to a door panel or rear speak-

er deck. There should be no gaps between the speaker basket and the mounting surface

6. Please handle the components with care, otherwise they will get damaged.

7. Please pay attention to the correct polarity (+ or -) for all terminals and connections.

8. Never connect the speakers to the electrical ground or with the body of the vehicle.

SETTINGS CROSSOVER ZXO2

If you want to change the factory settings (2-way operation, 0dB tweeter level), firstly remove the acrylic

glass cover of the crossover. Beneath you find three connector strips:

TWEETER LEVEL

Insert the jumper to the desired

position, choose between:

+ 3 dB

0 dB

- 9 dB

+ 3 dB

light increase

0 dB

no attenuation

– 3 dB

light attenuation

2-WAY-OPERATION

The jumpers TWEETER and

WOOFER must be on position

„2-WAY".

TWEETER

WOOFER

2-WAY

3-WAY

ENGLISH

3-WAY-OPERATION

The jumpers TWEETER and

WOOFER must be on position

„3-WAY".

TWEETER

WOOFER

2-WAY

3-WAY

NOTE: The connected midrange

driver at „OUT" must be operated

with a separate crossover to pro-

tect him for too low frequencies.