909 CXD1800 사용 설명서 - 페이지 10
{카테고리_이름} 909 CXD1800에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 CXD1800 12 페이지.
페이지 인쇄3. If a cord becomes damaged during use, turn off at power
point and disconnect the supply cord from the mains
immediately. Do not touch the cord before disconnecting
the power supply.
4. Always disconnect the appliance from the mains supply.
- Whenever you leave the machine;
- Before checking, cleaning or working on the appliance;
- If the appliance starts to vibrate abnormally.
5. Operate the appliance only in daylight or in good
artificial light.
6. Always be sure of your footing on slopes.
7. Walk, never run.
8. Always keep the vacuum inlet clear of debris before and
after use.
Operating your Blower/Vacuum
1. Ensure that the handle has been correctly fitted and
is firmly fastened to the machine (see assembly
instructions).
2. Always ensure that the soft catcher is fitted properly
before using (see assembly instructions).
3. Your Blower & Vacuum is
controlled by the lock off
switch (switching interlock
button) and the on/off lever
(switch operating handle).
When starting the machine,
firstly activate the On/off
interlock switch by pushing it
down. Whilst holding down
the On/Off interlock switch, squeeze the switch operating
handle towards the handle bar.
4. Proceed to use the machine with your hand grasping the
switch operating handle for continued use.
5. When you release the handle, the unit will automatically
stop.
Using the height adjustment
The appliance comes with
a special designed height
adjustment, for using on the
hard surface, patio, lawn and
garden area, etc.
1. Push down the adjusting
handle and move forward
to bring the vacuum inlet
close to the ground, for use
of vacuuming and blowing
on the hard surfaces.
2. Push down the adjusting
handle and move
backwards to bring the
vacuum inlet up higher,
for using on lawns,
garden beds or any other
rough surface.
Using the blow mode
1. Ensure the appliance is switched off and not connected
to the mains power.
2. Push the blow/suction conversion handle forward until it
clicks into position.
3. Plug the machine into
the mains power and the
machine is now set to the
blowing function. Proceed
to push/walk the machine
forward while air is blown
from the blowing outlet.
Note: Never blow any debris in
the direction of the bystanders.
10