909 CXD1800 사용 설명서 - 페이지 9

{카테고리_이름} 909 CXD1800에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 CXD1800 12 페이지.

Assembly

Your appliance comes with the fully assembled main unit,

the unassembled rear handle and soft catcher bag. Take it

out of the package, fit the handle and attach the bag, your

appliance is now ready to go.

1. Remove the two handle locking screws from their position

on the chassis by using a screwdriver, and keep them on

the side for next step.

2. Insert the two ends of the lower handle into the mounting

holes on the chassis as shown.

3. Attach the upper handle to the lower handle by placing

the end of the upper handle ends on the outer side of the

lower handles. Insert the locking screw through the lower

handle, then through the upper handle ensuring that the

square lock on the underside of the screw is sitting in the

square indent on the inner side of the lower handle.

Repeat for the opposite side.

Take care! Do not damage the power cable!

4. When in position, secure the handle by adding the wing

nut onto the screw on the outer side of the upper handle

and finger tighten until secure.

Repeat for the opposite side.

1. Hold the bag handle and place the bottom of the bag

frame in the supports on the rear part of the discharge

chute, then move forward and lock it with the bag

attachment lock.

2. There are four plastic hooks on each corner of the top of

the bag, click them onto the two sides of the lower handle

and make sure the bag is held properly.

Preparing for Operation

1. Connect to an extension cord. Loop the extension cord

through and around the cord restraint.

Always use an extension cord with heavy duty insulation

that is designed for outdoor use.

2. Always direct the cord to the rear, keep it away from the

appliance.