HIFU Ultraformer 3 매뉴얼 - 페이지 10

{카테고리_이름} HIFU Ultraformer 3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIFU Ultraformer 3 15 페이지.

3. Introduction to the main interface of the instrument:

1. Current Used times, Remain remaining times

2. Handle head information

3. Depth of the handle head, wavelength, spacing display (display only)

4. Set the distance between the condensation points

5. Set energy length (5mm-25mm, minimum adjustment interval 5mm)

6. M1, M2 save parameters (long press for 3 seconds to save)

7. Energy regulation

8. Repeat is continuous transmission mode Single is single transmission mode

9. Settings

10. Send number information

11. System status "standby" and "start"

12. Set the limit of the number of transmissions, and buzzer prompts

13.the total number of times used

Step:

Preparation: Plug in the handle and probe, then adjust the dot ④ density and ⑤ intensity to start

working (if you need to save the data, first adjust the required parameters, press and hold for 3 seconds

⑥ M1, M2 to save)

Start: first press ⑪ to start and then press the handle button, close to the skin, you can start

treatment

Stop: first press the handle button and then press ⑪ to stop, switch the mode by pressing ⑥ to

switch the mode.

Note: When CURRENT①<⑫ value, it can work; when CURRENT①=⑫ value, it means that the probe

times have been used up, and the instrument has a beep and cannot work.