DynaQuip WaterCop Classic 사용 설명서 및 설치 설명서 - 페이지 16

{카테고리_이름} DynaQuip WaterCop Classic에 대한 사용 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaQuip WaterCop Classic 20 페이지.

8 . Install compression nuts and sleeves to each tube end .

9 . Shift tube ends to install WaterCop® valve in line .

10 . Position the unit and tighten compression nuts . Hold the fitting with one wrench

while tightening the nut with the other . Tighten both nuts .

11 . Plug unit into a proper power source and turn valve to open position (OPEN

button/green light) .

12 . Unplug unit, turn water back on and carefully check for leaks .

13 . Tighten fittings if needed to stop any leaks .

14 . Plug unit back into power source . Installation is complete .

Solder Fittings

An alternative method is to solder the unit into the water line . This method requires a

considerably higher skill level to accomplish the installation properly and safely . If you

are not skilled in this area, it is strongly recommended that you contact a professional

plumber to do this type of installation .

Electrical Connections

The WaterCop® is supplied with a power adapter (20' cord) to be plugged into a

120 VAC power source . It is recommended that the WaterCop® not be plugged into

an extension cord .

Review "Specification" current and power requirements as not to overload the circuit

supplying power .

As with all valuable electronic items; we recommend plugging the WaterCop®

Actuator into a surge protector.

Warnings and Precautions

WARNING:

loads. Do no attempt to use the unit as a step. This will cause damage to the

unit and could cause personal injury. Do not store highly flammable items

such as oily rags or other combustibles near your WaterCop.®

CAUTION!

installing or servicing the system. Failure to do so could result in

personal injury.

CAUTION!

unit or tightening fittings. Apply wrench to flats on the valve body to

tighten fittings.

The motorized drive unit case is not capable of supporting any

It is recommended that eye protection be worn while

Do not use the case as leverage when mounting this