909 52299 사용자 설명서 - 페이지 13

{카테고리_이름} 909 52299에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 52299 20 페이지. 3500w inverter generator with pure sine wave

페이지 인쇄

Starting/Stopping the Engine

Starting the Engine

NOTE: Before starting the engine, ensure you have filled the oil tank to the

correct level with oil and fuel has been added to the fuel tank.

NOTE: The oil tank is NOT filled with oil from the factory.

1. Before starting, TURN OFF the master 240Va.c switch (13) to ensure that no

electrical apparatus is electrically connected to the generator (Fig. Q/R).

2. Turn the fuel tap / lever (26) clockwise to the 'on' position (Fig. S).

3. Push the choke lever (19) forwards (towards the front of the generator) to

the full choke "START" position (Fig. T). This is not necessary if the engine is

already warm.

NOTE: The direction for the choke is also indicated below the choke lever

(19) on the air filter cover (20).

4. Press the petrol motor On/Off switch (4) to the 'On' position as indicated by

an "I" (Fig. U).

NOTE: When the engine is started for the very first time, it may require a

number of attempts to start until the fuel has travelled from the tank to the

engine. Slowly pull the recoil starter (18) to full extent 2 or 3 times to assist

an enriched fuel mixture to enter the carburettor.

5. Slowly pull the recoil starter (18) until you feel it

engage and then pull it briskly (Fig. W).

6. Once you hear the engine operating, move the

choke lever (19) backwards slowly (towards

the rear of the generator) to the "RUN" position

(Fig. T). Allow the generator to run for a few

minutes unloaded to warm up before connecting

appliances to the output of the generator.

OFF

e-mail: [email protected]

MODEL: №. INF3800A • 52299

3500W Digital Inverter with Pure Sine Wave

OFF

RUN

START

AFTER SALES SUPPORT

1800 909 909

(toll free)

3500W Digital Inverter with Pure Sine Wave

Stopping the Engine

1. Before stopping, ensure that no electrical apparatus is electrically

connected to the generator . TURN OFF the master 240Va.c switch (13) to

turn off the power to the 3 AC sockets (12). You can also then remove any

plugs in any of the 3 AC sockets (12) on the control panel (14) (Fig Q/R).

2. Allow the petrol motor to slow down and idle for approx 30 seconds.

3. Press the On/Off switch (4) to the 'Off' position as indicated by an "O" (Fig. U).

4. Turn the fuel lever / tap (26) anti clockwise to the 'off' position (Fig. V).

Failure of the motor On/Off Switch

In the unusual event the motor On/Off switch (4) does not stop the petrol

motor of the generator, follow the following procedure to shut down the

generator:

1. Turn off the master 240Va.c switch (13) (Fig R), and remove all plugs from

the AC sockets (12) (Fig Q).

2. Ensure the On/Off switch (4) is in the "OFF" position (Fig U).

3. Move the fuel tap (26) to the OFF position (Fig V).

The generator will run for approximately 1 minute and then stop.

Do not use the generator again until the generator is serviced and the

fault corrected.

OFF