DynaQuip Controls WaterCop classic 사용 설명서 및 설치 설명서 - 페이지 11

{카테고리_이름} DynaQuip Controls WaterCop classic에 대한 사용 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaQuip Controls WaterCop classic 12 페이지.

8 . Install compression nuts and sleeves to each tube end .

9 . Shift tube ends to install WaterCop

10 . Position the unit and tighten compression nuts . Hold the fitting with one wrench while tightening the nut with the other .

Tighten both nuts .

11 . Plug unit into a proper power source and turn valve to open position (open button / green light) .

12 . Unplug unit, turn water back on and carefully check for leaks .

13 . Tighten fittings if needed to stop any leaks .

14 . Plug unit back into power source . Installation is complete .

Solder Fittings

An alternative method is to solder the unit into the water line . This method requires a considerably higher skill level to

accomplish the installation properly and safely . If you are not skilled in this area, it is strongly recommended that you

contact a professional plumber to do this type of installation .

The WaterCop

is supplied with a power adaptor (20' cord) to be plugged into a 120 VAC power source . It is recommended

that the WaterCop

not be plugged into an extension cord .

Review "Specification" current and power requirements as not to overload the circuit supplying power .

As with all valuable electronic items; we recommend plugging the WaterCop

WARNING!

STOP

The motorized drive unit case is not capable of supporting any loads. Do not attempt to use the

unit as a step. This will cause damage to the unit and could cause personal injury. Do not store

highly flammable items such as oily rags or other combustibles near your WaterCop

Caution:

It is recommended that eye protection be worn while installing or servicing the system. Failure to do

so could result in personal injury.

Caution:

Do not use the case as leverage when mounting this unit or tightening fittings. Apply wrench to flats

on the valve body to tighten fittings.

Codes on all control units and transmitters are set at the factory and should not require alteration . If you use other wireless

products in your home (garage door openers, etc . ) , there is a slight chance of interference with the signal . The following

instructions will aid in resetting the code .

Important Note: All transmitters and the control unit must have the same code setting!

Disconnect power to receiver unit by unplugging power cord .

1 . Remove cover using the 4 screws located in the corners of the cover .

2 . Locate code switch block (see illustration page 12) . Switches are numbered 1 through 8 .

3 . Arrange the switches in any combination (on or off position) . Write down the code combination you selected .

Example: 1-on, 2-off, 3-off, 4-on, 5-off, 6-on, 7-off, and 8-off .

DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077

Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com

valve in line .

Actuator into a surge protector.