Autonics BJR DDT Series 제품 설명서 - 페이지 3
{카테고리_이름} Autonics BJR DDT Series에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics BJR DDT Series 5 페이지. Oil-resistant photoelectric sensors
페이지 인쇄■ Reflector (MS-2S)
2-Ø3.8
2.5
3.25
34
8.5
40.5
Specifications
Model
BJR15M-TDT-□-□
Sensing type
Through-beam
Sensing distance
15 m
Sensing target
Opaque materials
Min. sensing target
≥ Ø 12 mm
Hysteresis
-
Response time
≤ 1 ms
Light source
Infrared
Peak emission
850 nm
wavelength
Sensitivity
YES (Adjuster)
adjustment
Mutual interference
-
prevention
Operation mode
Light ON mode - Dark ON mode selectable (Adjuster)
Operation indicator (yellow), stability indicator (green),
Indicator
power indicator (red)
Approval
ᜢ ᜫ
01) Reflector (MS-2S)
02) Non-glossy white paper 100 × 100 mm
03) Non-glossy white paper 300 × 300 mm
04) Only for the emitter
Unit weight
Through-
(packaged)
beam
≈ 95 g (≈ 145 g)
Cable type
Cable connector type ≈ 55 g (≈ 105 g)
Power supply
10-30 VDCᜡ ±10 % (ripple P-P: ≤ 10 %)
Current
It depends on the sensing type
consumption
Through-beam
Emitter: ≤ 20 mA, receiver: ≤ 20 mA
Reflective
≤ 30 mA
Control output
NPN open collector output / PNP open collector output model
Load voltage
≤ 30 VDCᜡ
Load current
≤ 100 mA
Residual voltage
NPN: ≤ 1 VDCᜡ, PNP: ≤ 2 VDCᜡ
Reverse power protection circuit, output short overcurrent protection
Protection circuit
circuit
Insulation resistance ≥ 20 MΩ (500 VDCᜡ megger)
±240 VDCᜡ the square wave noise (pulse width: 1 ㎲) by the noise
Noise immunity
simulator
Dielectric strength
Between the charging part and the case: 1,000 VACᜠ 50/60 Hz for 1 min
1.5 mm double amplitude at frequency of 10 to 55 Hz in each X, Y, Z
Vibration
direction for 2 hours
Shock
500 m/s² (≈ 50 G) in each X, Y, Z direction for 3 times
Ambient
Sunlight: ≤ 11,000 lx, incandescent lamp: ≤ 3,000 lx
illuminance (receiver)
Ambient
-25 to 60 ℃, storage: -40 to 70℃ (no freezing or condensation)
temperature
Ambient humidity
35 to 85 %RH, storage: 35 to 85 %RH (no freezing or condensation)
Protection rating
IP67 (IEC standard), IP67G (JEM standard)
Connection
Cable type / Cable connector type model
Ø 4 mm, 3-wire (emitter: 2-wire),
Cable spec.
cable type: 2 m, cable connector type: 300 mm
Wire spec.
AWG26 (0.52 mm, 20-core), insulator outer diameter: Ø 1 mm
Connector
M12 4-pin plug type
Case: ABS, CAP: PA12, sensing part: PMMA
Material
■ Bracket A
4-R1.7
3.4
2-R2
5
14
3
8-R1.7
2-R2
4-R23.7
(R)
15
22
BJR3M-PDT-□-□
BJR□-DDT-□-□
Polarized retroreflective Diffuse reflective
3 m
100 mm
01)
Opaque materials,
Opaque materials
translucent materials
≥ Ø 75 mm
-
≤ 20 % of sensing
-
distance
Red
Infrared
660 nm
850 nm
YES (Adjuster)
YES (Adjuster)
YES
YES
04)
ᜢ ᜫ
ᜢ ᜫ
Polarized
Diffuse
retroreflective
reflective
≈ 50 g (≈ 115 g)
≈ 50 g (≈ 100 g)
≈ 30 g (≈ 95 g)
≈ 30 g (≈ 80 g)
IP67G (JEM standard)
■ Used oil (for reference only)
Oil type
Lubricating oil
1.2
Water-insoluble
cutting fluid
Water-soluble
cutting fluid
• Special coating prevents penetration of oil (drops and powder) into the product. It obtains
the protection rating of enhanced oil resistance. (Pass the dropping test for 240 hours with the
above oil)
Sold Separately: Bracket B (BJP SERIES BRACKET B)
• Unit: mm, For the detailed drawings, follow the Autonics website.
1 m
02)
03)
-
Red
660 nm
Sold Separately: M12 Connector Cable
• For detailed information, refer to the 'M8/M12 Connector Cable' manual.
Appearance
Power
DC
DC
DC
DC
Kinetic viscosity
JIS standard
Oil name
(mm
ㅡ
Velocite Oil No.3
2
2-5
Tectyl Cut 527
27
ㅡ
Tectyl Cool 263C
ㅡ
(R)
30
26.5
R2
Ø3.4
R2
2-R1.7
2-R2
20°
Connector 1 Connector 2 Length Feature
M12 (Socket-
3-wire
Female) 4-pin
M12 (Socket-
3-wire
Female) 4-pin
M12 (Socket-
Female)
3-wire
4-pin, L type
M12 (Socket-
Female)
3-wire
4-pin, L type
PH
/s, 40℃)
2
ㅡ
ㅡ
9.5 (10% Solution)
4-R1.7
2-3.4
8
14
Model
2 m
CID3-2
PVC
5 m
CID3-5
2 m
CIDH3-2
Oil resistant
PVC
5 m
CIDH3-5
2 m
CLD3-2
PVC
5 m
CLD3-5
2 m
CLDH3-2
Oil resistant
PVC
5 m
CLDH3-5