activTek INDUCT 2000 소유자 매뉴얼 - 페이지 6

{카테고리_이름} activTek INDUCT 2000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. activTek INDUCT 2000 9 페이지. Electronic air purification system
activTek INDUCT 2000에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

FIBERGLASS DUCTWORK INSTALLATION

Stud

5. Insert (4) 2" Threaded bolts into screw holes at

corners of mounting plate. Attach (4) toggle bolt

anchors to ends of threaded bolts.

7. Insert (4) toggle bolts into 3/8" holes in duct. Be

sure toggle anchors open after inserting.

9. Insert unit into opening. Be sure the air will pass

though the ActivePure® cell honeycomb matrix.

11. Plug unit into working power receptacle. Hard wiring unit into

HVAC system should be done by a licensed HVAC installer or

electrical contractor only.

(CONTINUED)

6. Remove backing from mounting plate

adhesive gasket.

8. Center large opening in mounting plate over

3.5" opening in duct and press plate to duct.

The adhesive gasket will hold the mounting

plate into place.

Tighten toggle bolts - DO NOT OVERTIGHTEN.

10. Secure the unit to the mounting plate with (4)

#8-32 nuts.