High End Systems Power Cue Store 사용자 설명서 - 페이지 9

{카테고리_이름} High End Systems Power Cue Store에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. High End Systems Power Cue Store 19 페이지.

Use the slider to adjust these values, then press STORE. The display shows YES,

then the new value.

Loading Scenes Into the Power Cue Store

To load scenes into the Power Cue Store:

A number of attributes are stored with each scene. These are explained in the "Scene

Types" section.

As described in the section "Loss of Data Key", it is possible to program the Power

Cue Store to go to scene 00 when no DMX signal is received. Scene 00 may be

loaded into memory in pass-through mode just like any other scene, and it may be

selected in pass-through mode and then output in manual mode or external control

mode. However, scene 00 may not be accessed in manual mode or external control

mode.

Use the numeric buttons to select a scene between 00 and 63. The number of the

selected scene is shown in the display.

Select one of the following:

Lod 0: Blackout. Display shows —- on loss of data.

Lod 1: Holds the last valid signal received. Display shows —- on

loss of data.

Lod 2: Holds on scene 00. Display flashes 00 on loss of data.

Make sure the Power Cue Store is in pass-through mode by releasing

manual and/or external control as discussed below:

If the Power Cue Store is in manual control, press TAKE

CONTROL. DMX data must be present to return to pass-through

mode from manual control.

If the Power Cue Store is being controlled externally, release the

external control line. See "Remote Input Device" for more

information.

Output the desired scene from any DMX desk or controller.

Enter a scene number between 00 and 63 using the numeric buttons.

Press and hold the STORE button.

The display first shows Scn and then YES.

Release the STORE button.

The scene is now stored under the number you chose.

Power Cue Store

User Manual

Page 7