IHC suspension GM 1500 사용 설명서 - 페이지 3

{카테고리_이름} IHC suspension GM 1500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IHC suspension GM 1500 17 페이지. 5” rear drop- reverse hanger

It is imperative that you record the following measurements and factory components in the

tables below. IHC Suspension tests and records as much data from each application as

available at the time of product development. Vehicle manufacturers may change components

or add models with different options. Recording and not exceeding the fender-to-hub-center

IHC Suspension calls out will ensure the drop on the vehicle is correct.

These measurements will affect the performance of this lowering kit. Failure to ensure proper

stock conditions may result in over lowering, causing premature failure on ball joints, if 4wd,

axles, CV boots and drivetrain. Over lowering a vehicle will also result in an incorrect wheel

alignment. This will wear tires incorrectly. Incorrect alignment will cause poor vehicle handling

issues including but not limited to under steer. Over lowering the vehicle will also cause

incorrect suspension geometry resulting in poor ride quality accompanied by pops and clunks

which are symptoms of prematurely wearing components.

Failure to adjust head lamps may cause dangerous driving conditions for you and other drivers

on the road. Record the head lamp position before the installation of this lowering kit and

adjust to original factory position after the completion to ensure a safe and enjoyable

experience. Refer to Owner's Manual.

FRONT

REAR

**MEASUREMENT IS TO BE PERFORMED FROM CENTER OF HUB TO FENDER EDGE STRAIGHT

UP FROM HUB **

• Make sure vehicle is on leveled pavement.

• All 4 tires are same size (if running stagger fitment measurement will

vary)

• All 4 tires have corrected air pressure.

PRE-INSTALLATION MEASUREMENTS

VEHICLE HEIGHT MEASURMENTS

DRIVER BEFORE

DRIVER AFTER

PASS BEFORE

PASS AFTER