DCA Z1J-FF03-13 사용 설명서 - 페이지 3
{카테고리_이름} DCA Z1J-FF03-13에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCA Z1J-FF03-13 7 페이지. Electric impact drill
페이지 인쇄application. The correct power tool will do the job better and safer at the rate
for which it was designed.
18. Do not use tool if switch does not turn it on or off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source and/or the battery pack
from the power tool before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
20. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
VOLTAGE WARNING:
Before connecting the machine to a power source (receptacle, outlet, etc.), be
sure the voltage supplied is the same as that specified on the nameplate of the
machine. A power source with voltage greater than that specified for the machine
can result in SERIOUS INJURY to the user, as well as damage to the machine. If
in doubt, DO NOT PLUG IN THE MACHINE. Using a power source with voltage
less than nameplate rating is harmful to the motor.
-3-
SPECIFICATIONS
Rated Power Input
No-Load Speed
Blows
Steel
Max. Drilling Capacity
Wood
Net Weight
※ Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.
ADDITIONAL SAFETY RULES
1. Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord.
2. Wear ear protectors when impact drilling.
3. Use auxiliary handle(s), if supplied with the tool.
4. Always be sure you have a firm footing.
5. Ensure that the drill is firmly chucked before drilling.
6. Keep hands away from rotating parts.
7. Before drilling into walls, ceilings or floors, ensure that there are no
concealed power cables inside.
8. Do not leave the tool running. Operate the tool only when hand-held.
9. Do not touch the bit or the workpiece immediately after operation; they may
be extremely hot and could burn your skin.
10. Some material contains chemicals which may be toxic. Take caution to prevent
dust inhalation and skin contact. Follow material supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING! MISUSE or failure to follow the safety rules stated in this instruction
manual may cause serious personal injury.
500 W
0-1200 r/min
0-15600 .../min
13 mm
20 mm
2.5 Kg
-4-