DCA M1Q-FF-85 사용 설명서 - 페이지 5

{카테고리_이름} DCA M1Q-FF-85에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCA M1Q-FF-85 10 페이지.

페이지 인쇄

INSTRUCTIONS FOR OPERATION

Safety Protector

CAUTION:

Always keep the safety protector in

place during operation for your

safety.

The safety protector attached to the

housing prevents unintentional contact

with the saw blade while working and

should not be removed. (Fig. 2)

Switch Action

CAUTION:

Before plugging in the tool, always check to see that the trigger switch actuates

properly and returns to the "OFF" position when released.

Switch can be locked in the "ON" position for ease of operator comfort during

extended use. Apply caution when locking tool in the "On" position and maintain

firm grasp on tool.

To start the tool, simply press the

switch trigger. Release the trigger to

stop.

For continuous operation, pull the

trigger and then push in the lock

button. To stop the tool from the

locked position, pull the trigger fully

and then release it. (Fig. 3)

-7-

Speed Control

Speed can be infinitely adjusted between

500 and 3,100 strokes per minute by

turning the adjusting dial. Higher speed is

obtained when the dial is turned clockwise;

lower speed is obtained when it is turned

counterclockwise. (Fig. 4)

Installing or Removing the Saw Blade

CAUTION:

Always be sure that the tool is switched OFF and unplugged before installing or

removing the saw blade.

Wear protective gloves when replacing/removing the saw blade.

Always clean out all chips or foreign matter adhering to the blade and/or blade holder.

Failure to do so may cause insufficient tightening of the blade, resulting in a serious

personal injury.

Do not touch the blade or the workpiece immediately after operation; they may be

extremely hot and could burn your skin.

Always secure the blade firmly. Insufficient tightening of the blade may cause blade

breakage or serious personal injury.

To install the saw blade, firstly set the blade orbit selector lever to

level 3.

Then finish the installment as follows:

— Insert the blade into the stroke rod crosswise to the cutting

direction.

-8-