DCB FT-66 Series 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} DCB FT-66 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCB FT-66 Series 6 페이지.

To enter serial setup mode, attach the serial cable and press <enter> on your terminal. You should then

see a login prompt. Login using the name "setup" and follow the on-screen instruction.

Step 2: Accessing the Web Interface

To access the FT-66xx web interface use the following URL. Please note that it is https and not http.

https://192.168.0.1

Of course, if you changed the LAN1 IP address using the COM port, please use the new address in the

above URL.

You will get a security warning, then the web browser should pop up an authentication screen. If this

does not happen, see the

field blank. The name and password fields are case sensitive.

Important Notes:

After initial TLS negotiation, some web browsers will display a blank page. If this

●

happens, press the refresh button.

Your web browser must support the TLS 1.0 protocol. If you have trouble connecting,

●

check your web browser options to make sure TLS 1.0 is enabled. For IE, you will find

the TLS 1.0 setting under Advanced/Settings. For Firefox you will find it under

Preferences/Advanced/Security.

Internet Explorer Version 7 and newer or Firefox version 2 or newer are recommended.

●

Older versions of web browsers may fail due to TLS negotiation issues.

Firefox, Netscape, and Mozilla will not use the TLS 1.0 protocol if they have

●

encountered an error with a server. You must exit all instances of the browser then

restart it to clear the error condition.

Setup through the web interface is performed through web forms. There is a menu bar on the left side

of the window where you navigate and select the active form. The active form is displayed on the

right. You make changes to the form, then press the "submit" button to send the changes to the FT-

66xx. If you navigate to a different form without submitting it first, any changes will be lost.

As you go through the forms, you will notice that the each configuration item is hyper-linked. Clicking

the hyper-link will take you to a help page describing the configuration item in more detail.

Step 3: Configure LAN1

LAN1 will reside on your private network. Navigate to the LAN1 – IP Configuration form. Set the IP

address and subnet mask. The other fields on this page are typically not needed and may be left blank.

After making any changes, don't forget to press the "submit" button.

FT-66xx Quick Start Guide

Important Notes

below. Login using the name "admin". Leave the password

4/16/2020