Gale 3070 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Gale 3070에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gale 3070 12 페이지. 30 series

For safety reasons please read the following instructions and the enclosed
Important Safety Information carefully before attempting to connect your
subwoofer unit to the mains.
Warning
To reduce the risk of fire or electric shock, do not expose this appliance to
rain or moisture.
Caution
Use of controls or adjustments or performance of procedures other than
those specified may result in hazardous radiation exposure.
Caution
To reduce the risk of electric shock, do not remove cover (or back). There
are no user-serviceable parts inside. Please refer all servicing to a qualified
engineer.
The lightning flash with the arrowhead symbol within an
equilateral triangle is intended to alert the user to the presence
of uninsulated 'dangerous voltage' within the product's
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intend
ed to alert the user to the presence of important operating and
maintenance
(servicing)
accompanying the appliance.
This product complies with European Low
Voltage (73/23/EEC) and Electromagnetic Compatibility
(89/336/EEC) Directives when used according to this
instruction manual.
AP12401/4 Gale 3070 Owners' Manual (page three)

Important Safety Precautions

Plug Fitting Instructions (UK only)
The cord supplied with this appliance is factory fitted with a 13A mains plug
fitted with a 3A fuse inside.
important that a 3A one is used. If the plug needs to be changed because it
is not suitable for your socket, or becomes damaged, it should be cut off and
an appropriate plug fitted following the wiring instructions below. The plug
must then be disposed of safely, as insertion into a 13A socket is likely to
cause an electrical hazard. Should it be necessary to fit a 3-pin BS mains
plug to the power cord the wires should be fitted
as shown in this diagram.
wires in the mains lead of this appliance may not
correspond
identifying the terminals in your plug. Connect
them as follows:-
instructions
in
the
literature
Note
If a 13 Amp (BS 1363) type of plug is used a 3 Amp or 5 Amp fuse must be
fitted, either in the plug or adaptor, or on the distribution board
Print Pantone Black
for Koda
If it is necessary to change the fuse, it is
The colours of the
with
the
coloured
markings
BLUE
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured RED
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is marked with the letter 'E'
coloured GREEN.
E
GREEN /
YELLOW
FUSE
N
L
BROWN
CORD
GRIP
or
.
3