Autool CT-200 사용자 설명서 - 페이지 12

{카테고리_이름} Autool CT-200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 14 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지), 사용자 설명서 (14 페이지)

페이지 인쇄

Without return hose connecting:

The hose line connection of theengine without returnhose is

shown as in Fig.07.

Disconnect the fuel supply hoses (E, F) of engine fuel system

(wrap the connector when disconnecting the connector), and

then choose a proper connector and connect it to the E end.

Reconnect the fuel outlet hose of the unit well and make the

fuel return hose hanging. See Fig.07.

Stop the other end of the disconnected end (F) with a proper

stopper, (use when the fuel pump has the fuel return function

only) or remove the fuse of fuel pump or disconnect the power

cable of fuel pump.

Fig.07

1-C100 Cleaner & Tester; 2-Engine; 3-stopper; 4- Fuel-inlet hose

to engine; 5-Auto tank; 6-Auto filter; 7- Engine fuel supply hose;

8-Auto fuel pump;

Tidy up after on-vehicle cleaning

After the on-vehicle cleaning is completed, turn off the Auto

Ignition Switches restitute the link of the Auto fuel hoses then

start the Auto to check the leakage of Auto fuel system.

At last please clean the fuel tank and hose line with test liquid

(if there is residual detergent inside fuel tank, please.). The

detailed procedure is shown as follows: drain the liquid inside

the fuel tank out and dispose it on the clean degree, and then

fill little test liquid and turn on the power. Select ?Leakage

test? item and press key [RUN] to run the unit for about 2

When the unit stops, drain the test liquid from fuel tank and

dispose the liquid as related regulation.

Tidy up and make preparation for the next cleaning.