Autool CT-200 Kullanıcı Kılavuzu - Sayfa 12

Teşhis Ekipmanları Autool CT-200 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Autool CT-200 14 sayfaları. Injector cleaner & tester
Ayrıca Autool CT-200 için: Manuel (18 sayfalar), Kullanıcı Kılavuzu (14 sayfalar)

Sayfayı Yazdır

Without return hose connecting:

The hose line connection of theengine without returnhose is

shown as in Fig.07.

Disconnect the fuel supply hoses (E, F) of engine fuel system

(wrap the connector when disconnecting the connector), and

then choose a proper connector and connect it to the E end.

Reconnect the fuel outlet hose of the unit well and make the

fuel return hose hanging. See Fig.07.

Stop the other end of the disconnected end (F) with a proper

stopper, (use when the fuel pump has the fuel return function

only) or remove the fuse of fuel pump or disconnect the power

cable of fuel pump.

Fig.07

1-C100 Cleaner & Tester; 2-Engine; 3-stopper; 4- Fuel-inlet hose

to engine; 5-Auto tank; 6-Auto filter; 7- Engine fuel supply hose;

8-Auto fuel pump;

Tidy up after on-vehicle cleaning

After the on-vehicle cleaning is completed, turn off the Auto

Ignition Switches restitute the link of the Auto fuel hoses then

start the Auto to check the leakage of Auto fuel system.

At last please clean the fuel tank and hose line with test liquid

(if there is residual detergent inside fuel tank, please.). The

detailed procedure is shown as follows: drain the liquid inside

the fuel tank out and dispose it on the clean degree, and then

fill little test liquid and turn on the power. Select ?Leakage

test? item and press key [RUN] to run the unit for about 2

When the unit stops, drain the test liquid from fuel tank and

dispose the liquid as related regulation.

Tidy up and make preparation for the next cleaning.