Autool CT-200 매뉴얼 - 페이지 7
{카테고리_이름} Autool CT-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 18 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지)
페이지 인쇄
key.
3) Press Left or Right Arrow key to set up working time. (Normally, it is 2
minutes.)
4) Press RUN key.
5) Turn Pressure Adjusting Knob until the pressure is 0.25-0.3MPa..
6) Press Left or Right Arrow key to select proper injection pulse (default
value is 3MS).
7) When the working time is zero, the machine will stop.
8) Release the fluid into the pump after test is completed.
03 Medium Speed Test
1) Press Left or Right Arrow key to select Medium Speed Test.
2) Press RUN key.
3) The next steps are the same as what listed in 02 Idle Speed Test.
04 High Speed Test
1) Press Left or Right Arrow key to select High Speed Test.
2) Press RUN key.
3）The next steps are the same as what listed in 02 Idle Speed Test.
05 Accelerating Test
1) Press Left or Right Arrow key to select Accelerating Test.
2) Press RUN key.
3）The next steps are the same as what listed in 02 Idle Speed Test.
NOTE：
1. System pressure, working time and pulse width are set up
automatically by system itself. (Default working time cycle is 10
- - 7 - -