Autool CT-200 매뉴얼 - 페이지 6

{카테고리_이름} Autool CT-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 18 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지)

페이지 인쇄

a. Select the suitable coupler④ and "O" loop③, and then put the "O" loop

on the coupler. (Put a little lubricant on the coupler and the "O"loop.)

b. Put the injector⑨ into the coupler, and then put them together into the

fuel distributor⑥.

c. Install the hold plate②. Tighten the screw⑤ on the hold plate. Adjust

the suitable height by screw④.

d. Install the fuel distributor and injector to the fuel distributor rack⑦.

e. Connect the adaptor of black hose with the male terminal⑧ on the fuel

distributor. Connect the drive wire of injector, and prepare to test.

3.2.2 Steps

02 Idle Speed Test

1) Connect black hose (outlet) to inlet port of the fuel distributor, and

then connect the actuation cable to the machine.

2) Press Left or Right Arrow key to select Idle Speed Test, then press RUN

Installation Diagram

- - 6 - -