DCD 61400-000 사용 설명서 - 페이지 11

{카테고리_이름} DCD 61400-000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCD 61400-000 14 페이지. Lineman lasher

7b) Should slippage occur in the drive wheels, two screw adjustments have been

provided for easy maintenance. Take the hex wrench supplied with the

machine and turn the screws clockwise (left to right) to tighten. Do not tighten

too much as this will make the machine hard to pull and cause premature wear.

You are now ready to proceed to place the Lineman Lasher on the supporting

strand. Position the cable in the lasher. Close front and rear gates. Adjust rear

rollers to center cable. Raise the clutch handle to allow additional wire to be pulled

out of the machine without rotating the machine to tie off lashing wire to strand.

Attach towing rope to pulling rings on front of lasher.

Page | 10