DCD 61400-000 Operating Instructions Manual - Page 11

Browse online or download pdf Operating Instructions Manual for Industrial Equipment DCD 61400-000. DCD 61400-000 14 pages. Lineman lasher

Print Page

7b) Should slippage occur in the drive wheels, two screw adjustments have been

provided for easy maintenance. Take the hex wrench supplied with the

machine and turn the screws clockwise (left to right) to tighten. Do not tighten

too much as this will make the machine hard to pull and cause premature wear.

You are now ready to proceed to place the Lineman Lasher on the supporting

strand. Position the cable in the lasher. Close front and rear gates. Adjust rear

rollers to center cable. Raise the clutch handle to allow additional wire to be pulled

out of the machine without rotating the machine to tie off lashing wire to strand.

Attach towing rope to pulling rings on front of lasher.

Page | 10