9g Products INPRINT-MICRO 사용 설명서 - 페이지 8

{카테고리_이름} 9g Products INPRINT-MICRO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 9g Products INPRINT-MICRO 12 페이지.

TROUBLESHOOTING:

MOST PROBLEMS OCCUR WHEN

1) The finger was not positioned the same as

when originally enrolled.

2) The finger was slid into place too

quickly and did not wake up the sensors.

3) There was too much pressure at the front of

the finger. Uniform pressure is suggested.

4) The finger was applied at too much of an

angle to be read accurately.

It is important that you practice the sequence

several times to make sure that you have the

process correct. Once you have the positioning

learned, the INPRINT-MICRO will open quickly

and consistently.

BACK UP KEYS

If the INPRINT-MICRO becomes inoperable,

you will need to use your keys to open the door.

To access the contents of the INPRINT-MICRO

using the key, pull back the lock cover which

will give you access to the lock. Insert the key

into the lock and turn to release the door catch

which will open the front door.

CLEANING

To clean the surface of the INPRINT use a

mild soap and water and soft cloth only. Avoid

getting the sensor area wet.

CAUTION: Products that contain ammonia or chlorine if

sprayed on the fingerprint sensor could cause difficulties

reading and enrolling fingerprints and could damage the

INPRINT's finish.

To clean the sensor area, use a slightly damp,

dust free cloth to wipe the sensor area.

Do NOT overstuff your safe. If you fill the safe to where the door is bulging it may cause the locking

mechanism to jam. If this occurs please use the key to unlock and cycle the biometric lock with your

finger print after you have opened to reset.