9g Products INPRINT-MICRO Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для IP-контролери доступу 9g Products INPRINT-MICRO. 9g Products INPRINT-MICRO 12 сторінок.
Друкувати сторінку
TROUBLESHOOTING:
MOST PROBLEMS OCCUR WHEN
1) The finger was not positioned the same as
when originally enrolled.
2) The finger was slid into place too
quickly and did not wake up the sensors.
3) There was too much pressure at the front of
the finger. Uniform pressure is suggested.
4) The finger was applied at too much of an
angle to be read accurately.
It is important that you practice the sequence
several times to make sure that you have the
process correct. Once you have the positioning
learned, the INPRINT-MICRO will open quickly
and consistently.
BACK UP KEYS
If the INPRINT-MICRO becomes inoperable,
you will need to use your keys to open the door.
To access the contents of the INPRINT-MICRO
using the key, pull back the lock cover which
will give you access to the lock. Insert the key
into the lock and turn to release the door catch
which will open the front door.
CLEANING
To clean the surface of the INPRINT use a
mild soap and water and soft cloth only. Avoid
getting the sensor area wet.
CAUTION: Products that contain ammonia or chlorine if
sprayed on the fingerprint sensor could cause difficulties
reading and enrolling fingerprints and could damage the
INPRINT's finish.
To clean the sensor area, use a slightly damp,
dust free cloth to wipe the sensor area.
Do NOT overstuff your safe. If you fill the safe to where the door is bulging it may cause the locking
mechanism to jam. If this occurs please use the key to unlock and cycle the biometric lock with your
finger print after you have opened to reset.
8