Autopage C3 설치 매뉴얼 - 페이지 4

{카테고리_이름} Autopage C3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage C3 8 페이지. Telematics and tracking module
Autopage C3에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

Please be sure that your data module is downloaded with the

latest software and two-way protocol.

Never operate the C|3 when driving the vehicle.

Never leave small children or pets in an unattended vehicle.

Always install and test the remote starter or alarm system 100%

before proceeding to install the C|3. All operations must work

according to the manuals of these devices before C|3 is

installed.

Main Unit:

Mounting:

Mount the main C|3 unit in the interior of the vehicle. This may be

installed under the dash board or seating. Please insure that the unit is

close to the Alarm or remote start system so the data cables can be

connected. The unit can be mounted vertically or horizontally and must

be securely held to minimize vibration and movement that may impair the

driver's ability to operate the vehicle. Always solder all connections and

provide room to run the data, power and antenna cables.

Wiring:

Power connection:

Note: The power connection should be connected to the

proper power sources but not plugged in until the entire

installation has been complete. If the SIM card has not been

activated before power is applied to the unit, the unit will

need to be power-cycled after the SIM card is authorized by

unplugging the power and data connections for 5 seconds

and then plugging them back in.