Autopage C3 설치 매뉴얼 - 페이지 5

{카테고리_이름} Autopage C3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage C3 8 페이지. Telematics and tracking module
Autopage C3에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

The C|3 has 2 data plugs that need to be connected correctly for the

system to operate. These inputs are labeled and cannot be

interchanged. These cables will control the alarm and remote start

system as well as the data module if used. The cables can be

interchanged but they need to be connected to the proper socket for

correct operation.

Data Cable "A": This cable can be attached to an ADS data

module. This connection does not need to be made if no data

module is required for the installation.

Data Cable "B":

connector B and to the data port of the Auto Page alarm

or remote start system.

commands to the unit.

These data cables are encrypted and will ONLY work with Autopage C|3

compatible products and ADS data modules. Please insure the latest

software has been downloaded to the ADS module. Autopage One way

ADS units will operate but will have limited functionality. Please be sure

to chose the two-way protocol if available when updating or downloading

your ADS data module.

Antenna Mounting:

The C|3 unit comes with a combination GPS and GSM antenna. This

antenna should be mounted on the dash or rear deck of the vehicle with

a good view of the sky above. This is important for maximum

performance of the C|3 unit and these are the preferred locations. These

antennas can be mounted below a plastic dashboard or installed in the

dash but this will affect the performance of the antenna. Where a strong

cellular and GPS signal is present it is possible to mount these units

This cable must be connected to

This is vital to communicate