Autopage C3-RS-730 LCD 운영 매뉴얼 - 페이지 6

{카테고리_이름} Autopage C3-RS-730 LCD에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage C3-RS-730 LCD 18 페이지. Professional 2-way lcd remote car starter & alarm system with built in temperature, voltage sensor and two-way serial port data link

페이지 인쇄

1. Standard Lcd Icon Configurations

SVMASTER -

TAMPER DISARMING : If the alarm is triggered, upon disarm the system's siren will chirp 4 times, and the

parking lights will flash 3 times telling you the alarm has been triggered during the last armed state.

PATHWAY ILLUMINATION: When receiving an unlock /disarm signal, this feature will turn the parking lights

"ON" for 30 seconds and for 10 seconds upon the lock signal. (Programmable)

TWO STEPS DOOR UNLOCK (Optional): This feature will independently unlock the driver's door only when

disarming the security system. Pushing the

doors.

AUTOMATIC RE-ARM : If this feature is selected, the security system will automatically re-arm itself in 60

seconds after disarming with remote transmitter. Automatic rearm will cancel if any door is opened before

the 60 seconds timer has elapsed.

H. DISARMING WITHOUT A TRANSMITTER

OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:

The Override function may be used if the remote transmitter is lost or inoperative.

1. Enter the vehicle and turn the ignition switch to the 'ON' position.

2. (Alarm will sound.)

3. Within 10 seconds push and release the valet switch. The alarm will stop sounding and enter the disarm

mode. You can now start and operate the vehicle normally.

OVERRIDE THE ALARM WITH PASSWORD PIN CODE:

Unlike valet switch that can easily be found and defeated, this security system allows the consumer t o

program a password pin code offering a higher level of security.

1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)

2. Within 5 seconds, enter your chosen first digit code by pressing and releasing the Valet Switch. (When

finished above procedures, system's siren will stop alarming, lights will stop flashing, but the vehicle

can't be started.)

3. Within 15 seconds of the last digit code enter (the 1st code), then turn the Ignition Switch "OFF" and then

"ON".

4. Within 15 seconds, enter your chosen second digit code by pressing and releasing the Valet Switch.

5. Turn the ignition switch "OFF" position. 4 Chirps from siren/horn and 3 flashes from the parking light

indicate the system has disarmed.

Note: You must override the alarm within 60 seconds. If not, the system will automatically re-arm.

EXAMPLE: To Override the System with the Password Code 83,

1. Enter the vehicle and turn the ignition switch to the 'ON' position.

(Alarm will sound.)

2. Within 5 seconds, Press and Release the Valet Switch 8 times, (When finished the system's siren will

stop alarming, lights stop flashing, but the vehicle cannot be started or driven away.)

3. Within 15 seconds of entering the last digit code enter (the 1

"ON".

4. Within 15 seconds, Press and Release the Valet Switch 3 times.

5. Turn the Ignition Switch to the "Off" position. 4 Chirps form siren/horn and 3 flashes from the parking lights

will indicate the system has disarmed.

VALET MODE:

(System is in Disarm Mode )

The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your

transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm

functions and remote start functions are bypassed, however, the remote panic feature and remote door

SVMASTER -

http://www.msvmaster.lv

button a second time within 3 seconds will unlock the other

(Factory Default Setting)

code), turn the Ignition Switch "Off" and then

http://www.msvmaster.lv