Autopage RF-303 사용 설명서 - 페이지 4
{카테고리_이름} Autopage RF-303에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RF-303 18 페이지.
To replace the battery, carefully remove the case screw located at the end of the
remote transmitter where the key ring attaches to its case. Use a small blade
Phillips screwdriver. Before removing the battery note the direction of its
terminals. Install the new battery exactly the same, using caution so as not to
bend, or otherwise damage the battery contacts. Replace the case cover and
carefully tighten the screw. Do not over-tighten the screw. Test the transmitter
to be sure it arms and disarms the alarm.
B. LED STATUS INDICATOR OPERATION
1. LED OFF = The RF-303 is disarmed.
2. LED CONSTANT ON = Indicates opens trigger circuit.
3. LED FAST FLASHING = Passive arming timer is counting down.
4. LED FLASHING = The RF-303 is armed.
5. LED FLASHING IN A 2 FLASH/HOLD SEQUENCE = Alarm breach.
NOTE: If the automatic rearm feature was chosen at the time of installation, a
door must be opened after disarming. If a door is not opened, the RF-303 will
automatically rearm in 60 seconds, and the LED will continue to flash. See
Section (F ) AUTOMATIC REARMING for details.
C. AUDIBLE AND VISUAL ALARM STATUS INDICATOR
1. 1 CHIRP (VEHICLE HORN, OR SIREN) WITH 1 LIGHT FLASH
Alarm is armed.
2. 2 CHIRPS (VEHICLE HORN, OR SIREN) WITH 2 LIGHT FLASHES
Alarm is disarmed.
3. 4 CHIRPS (VEHICLE HORN, OR SIREN) WITH 4 LIGHT FLASHES,
& LED FLASHING IN A 2 FLASH/HOLD SEQUENCE
Alarm is disarmed and has been breached in your absence.