Autopage RF-700 사용 설명서 - 페이지 13

{카테고리_이름} Autopage RF-700에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RF-700 20 페이지. Vehicle security system

IMPORTANT NOTE: PROGRAM COMMANDS must be reentered and TEST MODE turned off

before any alarm function is possible.

You may also test the RF-700 actively (when armed) by opening any protected opening, or sharply

kicking one of the vehicle's tires.

If triggered in the armed condition, the RF-700 will sound the vehicle horn or siren, and flash the

parking lights for 30 or 60 seconds depending upon which alarm run time was chosen at the time of

installation. It will then stop and automatically reset and rearm. If the violation continues, the alarm will

sound and the lights will flash for two (2) 30 or 60 seconds cycles.

G. REMOTE CONTROL TRUNK/HATCH RELEASE FEATURE (Optional)

The RF-700 remote transmitter may be used to release your vehicle's trunk or hatch release. (*)

To remotely release the vehicle trunk or hatch, if the alarm is armed, press the DISARM button on the

remote transmitter, then press the TRUNK button for one second. The trunk or hatch will automatically

release. If the alarm is disarmed, press only the TRUNK button for one second. (**)

(*) Your vehicle must be equipped with an electronic trunk or hatch release.

(**) If the alarm was armed and you do not intend to drive the vehicle, you must rearm the RF-700.

H. SHOCK SENSOR (P)

The standard SIS-5 shock sensor will trigger the RF-700 when, for example, a window is broken, or

when the body of the vehicle is subjected to a shock, such as being struck by another vehicle when

parked.

Because vehicles vary greatly, the amount of sensitivity needed to trigger the SIS-5 will also vary. The

SIS-5 is adjustable through the remote transmitter to allow precise adjustment to accommodate the

needs of your vehicle. Consult the program commands flow chart for shock sensor adjustment.

NOTE: As a rule of thumb, over-adjustment will result in frequent false triggers, under-adjustment will

result in poor response should a violation occur.

NOTE: Adjusting the SIS-5 will also affect adjustment of its own prewarning circuit. However, any

other added sensors, either trigger or prewarning, will not be affected. Those sensors must be adjusted

separately.