Autopage RF-700 사용 설명서 - 페이지 15

{카테고리_이름} Autopage RF-700에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RF-700 20 페이지. Vehicle security system

The RF-700 includes two, 4 button mini remote control transmitters with LCD (Liquid Crystal Display)

readouts which must be programmed to the alarm before any alarm function is possible. This action is

normally done at the time of installation, however there may be occurrences when you wish to enter the

programming mode.

NOTE: Each time the programming mode is entered, all previously programmed transmitter codes will

be automatically deleted and must be reprogrammed. This is an important security feature. If any

transmitter is lost or stolen, enter the programming mode and reprogram existing transmitters.

Transmitters can only be programmed by entering the programming mode.

NOTE: Any transmitters programmed to the RF-700 will remain in memory during times when certain

vehicle service procedures make it necessary to disconnect the battery.

To program the RF-700 transmitters, follow the directions as written below, in their exact order!

To enter the programming mode switch the ignition ON, then push the momentary valet/override switch

five times. The siren or horn will chirp three times. Push the ARM button on one of the transmitters.

The siren or horn will chirp one time to confirm the RF-700 has accepted the code. Push the ARM

button on the remaining transmitter. The siren or horn will chirp one time to confirm the RF-700 has

accepted the code. To close the programming mode, switch off the ignition.

NOTE: The RF-700 will accept up to four transmitters. Consult your AutoPage dealer for the

purchase of additional transmitters.

1. TWO AND THREE VEHICLE OPERATION (M)

Press the MODE button on the transmitter to select CAR #2 or CAR #3. Consult the MODE

COMMANDS flow chart for details.

VEHICLE #2 (*)

Enter the programming mode on vehicle #2 and push the ARM button on the transmitter. The vehicle

horn or siren will respond with a confirming chirp.

VEHICLE #3 (*)

Enter the programming mode on vehicle #3 and push the ARM button on the transmitter.

The vehicle horn or siren will respond with a confirming chirp.

(*) All vehicles must be equipped with RF-700 alarm systems.

NOTE: If the transmitter for the primary vehicle has been programmed to operate one or two other

vehicles, it will not be possible to set PROGRAM COMMANDS on CAR #2 or CAR #3 with the