Autopage AP4000EX 사용 설명서 - 페이지 6

{카테고리_이름} Autopage AP4000EX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage AP4000EX 17 페이지. Access point
Autopage AP4000EX에 대해서도 마찬가지입니다: 작동 및 설치 매뉴얼 (15 페이지)

페이지 인쇄

THE AP4000EX WITHOUT AN ANTENNA WILL RESULT IN DAMAGE TO THE TRANSMITTER

PORTION OF THE SYSTEM. SUCH DAMAGE WILL NOT BE COVERED UNDER THE WARRANTY.

ANTENNA CONNECTION

1. If the existing car radio antenna is used, disconnect the vehicle's radio antenna cable from the radio. Plug the vehicle

antenna into the terminal of the AP4000EX main unit marked CAR ANTENNA. Plug the supplied coax jumper cable

into the terminal of the AP4000EX marked CAR RADIO. Plug the remaining end of the coax jumper into the vehicle's

radio.

2. If the vehicle is equipped with a fully automatic power radio antenna and you wish to use this antenna for the

AP4000EX, and optional relay must be used to automatically raise and lower the antenna during the paging cycle.

VEHICLE FULLY AUTOMATIC

POWER ANTENNA. (SEE NOTE #1 BELOW)

VEHICLE

ANTENNA

RELAY

CUT

VEHICLE RADIO

12 VOLTS CONSTANT

OPTIONAL

RK-1 RELAY

YELLOW (ANTENNA ACTUATOR CONTROL)

SUPPLIED

COAX

JUMPER

CAR RADIO

ANTENNA

NOTE #1 THIS ANTENNA MUST BE FULLY

AUTOMATIC FOR PROPER OPERATION.

READ THE MANUAL FOR OTHER WARNINGS

AND CAUTIONS.

CAUTION: DO NOT ATTEMPT TO CONNECT

MORE THAN ONE ANTENNA TO THE

TRANSMITTER.

[FIGURE 3]