Autopage AP4000EX 사용 설명서 - 페이지 8

{카테고리_이름} Autopage AP4000EX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage AP4000EX 17 페이지. Access point
Autopage AP4000EX에 대해서도 마찬가지입니다: 작동 및 설치 매뉴얼 (15 페이지)

페이지 인쇄

USES, CALL THE AUTOPAGE TECHNICAL DEPARTMENT AT 800/262-2526, EXTENSION 451 FROM

7:30 AM TO 5:00 PM PST. FAILURE TO FOLLOW THE ABOVE WARNINGS WILL CAUSE DAMAGE TO

THE VEHICLE AND THE PAGER MAIN UNIT, AND WILL NOT BE COVERED UNDER THE WARRANTY.

INSTALLING AS A STAND-ALONE SYSTEM

1. AFTER you have determined the location of a constant battery source for connection of the AP4000EX control unit,

you must also determine a source of switched 12 volts from the ignition switch. This source, usually found in the ignition

switch harness, will show constant voltage when the key is "ON" and the engine is running. This voltage source must be

eliminated when the engine is switched "OFF". WARNING: DO NOT DISREGARD THIS STEP! CONNECTION

OF THE VEHICLE'S SWITCHED IGNITION TO THE WHITE WIRE OF THE AP4000EX IS VERY

IMPORTANT. THIS CONNECTION WILL TURN OFF THE AP4000EX SO IT WILL NOT BE ALLOWED

TO TRANSMIT A SIGNAL DURING VEHICLE OPERATION.

2. After securing the main control unit (*), connect the SWITCHED IGNITION as determined in the above step to the

WHITE ignition input wire.

(*) DO NOT SECURE THE PAGER MAIN CONTROL UNIT TO ANY AIR BAG RELATED WIRE HARNESS

OR COMPONENT.

WHITE

(SWITCHED IGNITION INPUT)

ACCESSORY

OFF

IGNITION SWITCH

3. When installed as a stand-alone system, triggering of the AP4000EX will be from the vehicle's pin switch (dome

light) circuit. Connect in the following manner. For POSITIVE switched vehicles (most Fords), connect a wire from

the switched side of the vehicle's pin switch to the VIOLET input wire of the AP4000EX. For NEGATIVE switched

vehicles, (most, except Fords) (*), connect a wire from the switched side of the vehicle's pin switch to the GRAY input

wire of the AP4000EX.

(*) Some late model Ford vehicles now use a NEGATIVE pin switch system. Check carefully before making the

connection.

RUN

START

BATTERY

[FIGURE 5]