AutoPets Feeder-Robot 사용 설명서 - 페이지 8

{카테고리_이름} AutoPets Feeder-Robot에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AutoPets Feeder-Robot 19 페이지.

페이지 인쇄

hand-wash with mild soap the following removable parts:

the Hopper, Hopper Insert, the Hopper Lid (underside only),

the Dispenser, the Dispenser Flap, and the Food Bowl(s).

Optional: Hand-wipe non-removable parts that touch pet food: The

Food Chute, the Food Bowl Holder, and the Status Indicator Tower.

Do NOT submerge the Feeder-Robot Base or Control Panel in water.

Let all parts air dry completely before reassembling the

Feeder-Robot.

Placement

Place the Feeder-Robot in the same location as the previous

feeding device (at least during transition).

Make sure the unit is on a level surface. It can be placed on hard

flooring or carpet, as long as it is level.

Locate the unit near a power outlet (cord is 6 feet long).

Do not place or store the Feeder-Robot where it can fall or be

pulled into a tub or sink.

To avoid tripping, always position power cord out of the way of

foot traffic.

Do NOT use outdoors. FOR INDOOR HOUSEHOLD USE ONLY.

Plug It In

Note: Plug in the Feeder-Robot BEFORE adding

food to the Hopper.

Install the small plug end of the

power supply cord into the socket

underneath the unit (see image to

the right for location)

Then plug the power supply into a

wall outlet.

877. 250.7729 | feeder-robot.com

Power Input

Add Food

Remove the Hopper Lid by squeezing the Hopper Lid Release in the

center of the Hopper Lid (see page 8 for location). Use the built-in hook

on the underside of the Hopper Lid to hang it on the rear of the unit.

Hopper

Lid Hook

Add food: With the Hopper Insert, you can add up to 25 cups of

kibble. Without the Hopper Insert, you can add 30-32 cups of kibble.

Make sure food is level. If you have small, round-shaped kibble, the

Hopper Insert may not be required.

Situate The Food Bowl

Important: The Food Bowl design is shaped like a wedge. Make sure

the narrow end of the Food Bowl is placed under the Food Ramp Lip

(see illustration below). If the Food Bowl is not aligned in this way, the

dispensed food may catch along the edge of the Food Bowl, preventing

it from filling properly.

Place Food Bowl

Under Food Ramp Lip

877. 250.7729 | feeder-robot.com

Fill Line