DCI Edge SERIES 5 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} DCI Edge SERIES 5에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCI Edge SERIES 5 13 페이지. Side delivery system
DCI Edge SERIES 5에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (11 페이지), 사용 설명서 지침 (8 페이지), 설치 지침 매뉴얼 (14 페이지), 사용 설명서 지침 (19 페이지)

페이지 인쇄
DCI Edge SERIES 5 설치 지침 매뉴얼
SERIES 5 DENTAL CHAIR
Installation Instructions

DIAGNOSTIC CODES

Status Codes are displayed on two 7-segment displays on the main chair control circuit board. These are visible through
the clear window of the protective cover. Errors are designated with an 8 as the first digit. While there are error codes
displayed, no other input or output code will be displayed. When more than one code's condition is present, each
applicable code will will be displayed, alternating every second.
POSITION CONTROLS
Display
Status
00
System Normal, No current action
10
Foot switch key is currently being
pressed
11
Keypad 1 is currently being pressed
12
Keypad 2 is currently being pressed
13
Keypad 3 is currently being pressed
14
No motion in progress while keypad
is pressed
15
Backrest in motion
16
Base in motion
17
Auto-position in progress
18
Auto-position in progress
SAFETY SWITCHES
Display
Status
30
Safety cover switch engaged
31
Auxiliary Switch engaged
12
If this status is incorrect
Examine keypads and
connections
Foot switch may have a stuck
key
Keypad 1 may have a stuck key
Keypad 2 may have a stuck key
Keypad 3 may have a stuck key
Examine connections and
hydraulic systems
(normal function)
(normal function)
(normal function)
(normal function)
If this status is incorrect
Examine connections
Examine connections
SERIES 5 DENTAL CHAIR
POSITION INDICATORS
Display
Status
20
Signal received to move backrest but
it has reached its soft limit
21
Signal received to move base but it
has reached its soft limit
22
Signal received to move both base
and backrest but both have reached
their soft limits
Display
Status
80
Backrest Position value too low
81
Backrest Position value too high
82
Base Position value too low
83
Base Position value too high
84
Corrupt signal received by the main
chair PCB
Installation Instructions
If this status is incorrect
Reprogram soft limits
Reprogram soft limits
Reprogram soft limits
ERROR CODES
If this status is incorrect
Check soft limits
Check soft limits
Check soft limits
Check soft limits
Turn the chair off for 10 seconds
and then back on. If it still
persists, check connectors and
wire harnesses