Galil DMC-30010 설치 매뉴얼 - 페이지 5

{카테고리_이름} Galil DMC-30010에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galil DMC-30010 17 페이지. Dmc-3xx1 series integrated amplifier

Recommended shielded Cat 5 STP cable. Straight-through or Cross-over.

6. RS-232 straight-through serial cable

9 pin D-sub female

7. Molex pin Crimp Tool

8. Additional cables may be required for connection to motors, external amplifiers, digital or

analog I/O, and other devices. See the full DMC-3xx1x User Manual for further information.

9. Disconnect switch or circuit breaker for AC power to DC Power Supply

Unpacking the Controller

Caution:

The DMC-3xx1x motion controller and included internal amplifier include electrostatic

sensitive components. Observe standard precautions for handling ESD sensitive devices

when handling the controller.

1. Verify that the following components have been shipped along the motion controller.

•

Connectors and mating pins for motor power and amplifier power.

Qty 1 – 4 pin molex connectors (DMC-3xx12)

Qty 1 – 2 pin molex connector (DMC-3xx11 and DMC-3xx12)

Qty 1 – 4 pin molex connector (DMC-3xx10)

•

Galil Software Installation CD

Note:

Connectors and/or software installation CD may not be shipped to existing OEM

customers.

2. Check that no visible damage has occurred to the controller, or internal amplifiers. If any

damage has occurred to the controller, or the components shipped with the controller, contact

Galil Motion Control immediately. Contact information can be found in the beginning of this

manual.

3. Verify the controller that has been shipped to you is in fact the controller that you have

ordered from Galil or your authorized Galil distributor. To do this, check the labeling on the

controller and compare it to the part number that was ordered.

Figure 1: Label for DMC-3xx10

Figure 2: Label for DMC-3xx11