Autopilot APCG4NG 매뉴얼 - 페이지 8

{카테고리_이름} Autopilot APCG4NG에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopilot APCG4NG 13 페이지. 4 burner co2 generator (lp or ng)

Page 7

APCG4

High Altitude units

The standard brass burners have been designed to operate

correctly at an altitude between sea level and 4500 Ft of

elevation. If you are at an altitude higher than 4500 feet, do

not use the standard unit if yellow flames are visible. HA (High

Altitude) burners are available by contacting the factory.

If you are using the HA version of the APCG4, the burners are

designed to run leaner so that the lower oxygen level at

altitude will not affect the proper and complete combustion of

the fuel. As a result of the leaner burner calibration, the HA

version of the generator is going to produce lower CO2 output

The standard NG and LP brass burners have been designed

to produce approximately 3 Cu Ft of CO2 per hour. When the

HA (high-altitude) burners are used, the CO2 output and BTU

of each burner is reduced by approximately 15%.

The HA units be used at lower than 4500ft (down to as low as

2500ft) elevation as long as the burners are lighting (igniting)

correctly. If you plan on using the HA unit at lower elevations,

first ensure that all burners are lighting correctly and

consistently before use.

!!WARNING!! Verify that the burners are operating

correctly.

* A burner that is burning very yellow indicates a rich

condition, or possibly low oxygen levels.

* Burners that do not consistently ignite could be clogged

or not be receiving enough gas pressure.

* A burner that burns almost invisibly with a clean blue-

white flame is running correctly.