Dynasty Fireplaces EF60US 주택 소유자 설치 지침 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} Dynasty Fireplaces EF60US에 대한 주택 소유자 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynasty Fireplaces EF60US 9 페이지. Electric heater with remote control

페이지 인쇄

Magnet

1.5 Install the front onto the insert by locating the pole on both sides well, and slightly push the trim

bottom to fit the engine by magnets. Installation is completed.

2. With front TE3/TE4

2.1 Fix the insert into the mantel as step 1.2 & 1.3 & 1.4, locate the front onto the engine by the pole on

both sides and push down, then fix the trim by 2pcs of ST4*8 screws.

Plug the power supply cord into a wall outlet (120Vac, 60Hz).The cord has a plug as shown at A.

You should follow as shown at the below:

ELECTRICAL CONNECTION

A 15 AMP, 120 Volt, The unit comes standard with 6 feet (1.8 m) three wire cord, exiting from the rear of

the fireplace. Plan the installation to avoid the use of an extension cord. Preferably, the fireplace will be

on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the

fuse to blow when the heater is in operation.

Pole

GROUNDING

Grounding methods

Screw ST4x8