Galileo Quark SoC X1000 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Galileo Quark SoC X1000에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galileo Quark SoC X1000 20 페이지.

7. Click Install on the next Windows Security window that pops up. And, after a number of

loading-bar-scrolls, the installation should complete and you should be greeted with a

Windows has successfully updated your driver software window.

8. Look back at the Device Manager, under the Ports tree now. There should be an entry for

Galileo (COM #). Remember which COM # your Galileo is assigned, it'll be important for

Arduino sketch uploading and the next step,

Mac OS X Driver Install

Mac has built-in driver support for the Galileo, so this setup should be easy. Follow the steps below

to install the board on your machine:

1. Begin by connecting 5V power to the Galileo.

2. Then connect a

USB socket on your computer.

3. Wait a few seconds while the Galileo boots up. To verify the Galileo has enumerated properly,

open the System Information window (Hold Option > Click the Apple menu in the top left >

Click System Information), and check under the USB tab for a Gadget Serial v2.4 entry.

from the USB Client port on the Galileo to an available

micro-B USB cable

updating

firmware.

Page 10 of 20